Loading ...
Loading ...
Loading ...
5. Move your right hand to the position shown at the right,
and hold the treadmii_ firmly. Using your left hand. !iff the
storage latch. Raise the treadmill until the locking pin
snaps into the storage latch. Make sure that the locking
pin is inside the storage latch, and that the storage
latch is fully closed.
.See drawing 6B. Attach a Base Pad (95) to the bottom of
the Stabilizer Plate (98) in the indicated location.
See drawing 6A. Stand behind the treadmill. Hold the Left
Crossbar Bracket (3) and the Right Crossbar Bracket (not
shown). Place one fobt on the Base (73) in the indicated
location. Tip the treadmill back slightly.While the tread-
mill isheld in this position, asecond person shouldslide
the Stabilizer Plate (98) onto the Base (see drawing 6C).
Keeping yourfoot on the Base, carefully tip the treadmill
up until itis resting on the Base. Make sure that the
Stabilizer Plate (98) stays on the Base.
See drawing 6C. Attach the Stabilizer Plate (98) to the
Base (73) with aStabilizer Plate Bolt (91), two Stabilizer
Plate Washers (70), and the Stabilizer Plate Nut (71) as
shown.
.Refer to assembly drawing 5 at the top of this page. Hold
the upper end of the treadmill with your right hand as
shown. Using your left hand, liftthe storage latch. Pivot
the treadmill slightlyuntil the locking pin is out of the stor-
age latch.
°Hold the treadmill firmly with both hands, and lower the
treadmill to the floor, To decrease the possibility of in-
jury, bend your legs and keep your back straight.
8: Remove the paper backing from the Adhesive Clip (26).
Press theAdhesive Clip onto the Frame (49) in the indi-
cated location. Press the Allen Wrench (83) intothe
Adhesive Clip. The use of the Allen Wrench is described
on page 12.
Make sure that all parts are tightened before you use the
treadmill. Note: To protect the floor or carpet, place a
mat under the treadmill.
torage Latch_
6A 6B
95----_
98
7
,..._)/ 71,70"
49
Loading ...
Loading ...
Loading ...