Loading ...
Loading ...
Loading ...
TROUBLE-SHOOTING AND STORAGE
Most treadmill problems can be solved by following the simple steps below. Find the symptom that ap-
plies, and follow the steps listed. If further assistance is needed, call our toll-free HELPLINE at 1-800-736-
6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a surge protector, and that the surge protector isplugged into
a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) Use onlya UL-listed
surge protector, rated at 15 amps, with a 14-gauge cordof five feet or less in length.
b. After the power cord has been plugged in, make sure that the key is fully inserted intothe console. Vadous
indicators on the console should light. (See step 1 page 8.)
c. Check the circuit breaker located on the treadmill near the
power cord. If the switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
d. Check the on/off switch located at the front of the treadmill
near the power cord. The switch must be in the "on" position.
Tripped Reset
"On" "_
Position
2. SYMPTOM" THE POWER TURNS OFF DURING USE
a. Check the circuitbreaker located on the treadmill frame near the power cord. If the circuit breaker has
tripped (see the drawing above), wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console. (See step 1on page 8.)
d. Check to make sure that the on/off switch is in the =on" position. (See 1. d. above.)
e. If the treadmill stillwillnot run, please call our toll-free HELPLINE.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Use only aUL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.
b. Ifthe walking belt stillslows when walked on, please call our toll-free HELPLINE.
12
4..SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the 3/16" end of the allen
wrench, turn the left rear roller adjustment bolt clockwise 1/4 of a
turn. Plug in the power cord, insert the key and runthe treadmill
for a few minutes. Repeat until the walking belt is centered.
a
Loading ...
Loading ...
Loading ...