Loading ...
Loading ...
Loading ...
Operating your Appliance
WATER DRAINAGE
There are two ways to dispense collected water:
Internal Water Tank (Picture 1)
1. When this tank is full, the unit will automatically stop running, and the Tank Full Indicator light will
begin to flash red.
2. Grip the tank by its handle securely and carefully pull it out.
3. Empty the water tank and reinsert it into the dehumidifier. It will operate again once the tank is
securely back in place in the correct position.
DO NOT remove the tank immediately after the unit stops. Please wait a while to avoid water
dripping into the unit thus, damaging the unit or cause an electrical hazard.
DO NOT remove or damage the float switch in the water tank. This will cause the machine to not work
properly and can result in overflowing the tank.
Continuous Drainage (Picture 2)
1. Cut off the cover for the continuous drain, located on the back of the unit.
2. Pull out the water tank and connect a water tube or plastic pipe with a 10mm inner diameter (Not
included) to the drain continuous drain hole. Ensure that the connection is tight.
3. Return the water tank back into its normal position within the unit.
This allows the water to be automatically plumbed in or drained into a sink, a larger receptacle, or
through the wall into an outside drain.
NOTE: The unit uses gravity fall to dispose water, so the drain should be lower than the dehumidifier
water outlet. To ensure smooth water flow, run the pipe downward and DO NOT bend the pipe.
Picture 1
Picture 2
Loading ...
Loading ...
Loading ...