Loading ...
Loading ...
Loading ...
en Installation instructions
36
18.3 Electrical connection
In order to safely connect the appliance electrically, fol-
low these instructions.
WARNING‒Risk of electric shock!
Incorrect installation is dangerous.
▶ Only a qualified electrician may route the socket or
replace a power cable while taking into considera-
tion the applicable regulations.
▶ Connect the appliance only to a correctly installed,
earthed socket.
▶ If the plug is no longer accessible following installa-
tion, an all-pole isolating unit with a contact clear-
ance of at least 3mm must be available on the in-
stallation side. Contact protection must be ensured
by the installation.
18.4 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The installation cabinet must not have a back panel be-
hind the appliance. Maintain a clearance of at least
35mm between the wall and the cabinet base or the
rear panel of the cabinet situated above.
The installation cabinet must have a ventilation opening
of 50cm² on the front. To do this, trim the base panel
or fit a ventilation grille. Do not cover ventilation slots
and air intake openings.
18.5 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
18.6 Installation below a worktop
Observe the installation dimensions and the safety
clearances when installing below a worktop.
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
If the appliance is installed below a hob, observe the
hob installation instructions.
18.7 Corner installation
Observe the installation dimensions and the safety
clearances when installing in a corner.
18.8 Installing the appliance
1.
Centre the appliance.
2.
Screw the appliance onto the unit.
18.9 Removing the appliance
1.
Disconnect the appliance from the power supply.
2.
Undo the fastening screws.
3.
Lift the appliance slightly and pull it out completely.
Loading ...
Loading ...
Loading ...