Loading ...
Loading ...
Loading ...
mllolrleT_'_##1ld
• Remote control
Problem Cause See
page
Wrong distance or angle. 24
The remote control does not
work and/or function
properly.
Cannot operate external
components with the remote
control of this unit.
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
The batteries are weak.
The external component you want to operate
is not selected as the input source.
The remote control code was notcorrectly
set.
Even if the remote control code is correctly
set, there are some models that do not
respond to the remote control.
Remedy
The remote control functions within a
maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front panel.
Reposition this unit.
Replace all batteries.
Press INPUT on the front panel or the input
selector buttons on the remote control to
select the external component you want to
operate.
Set the remote control code correctly or try
another code for the same manufacturer
using the "List of remote control codes" at
the end of this manual.
Use the remote control supplied with the
external component.
24
39
94
The cursor buttons do not The operation mode selector was Set the operation mode selector to YSP. --
work during SET MENU unwantedly set to TWAV.
operation.
Cannot use the My Beam Wrong distance or angle. The remote control functions within a 24
auto-adjust function, maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front panel.
• HDMI
See
Error message Cause Remedy
page
Device Error The number of the connected HDMI Reduce the number of the connected HDMI --
components exceeds the limit, components.
HDCP Error HDCP authentication failed. Check that the connected HDMI --
components support the HDCP copy
protection standards.
Out of Resolution The resolution of the HDMI output signals Adjust UP-SCALING. 84
exceeds the limit allowed by your TV.
• FM tuner
Problem Cause See
page
FM stereo reception is noisy. 23
The characteristics of FM stereo broadcasts
may cause this problem when the
transmitter is too far away or the antenna
input is poor.
There is multi-path interference.
The signal is too weak.
There is distortion, and clear
reception cannot be obtained
even with a good FM
antenna.
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
Adjust the antenna position to eliminate
multi-path interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Preset the stations again.
The desired station cannot
be tuned into with the
automatic tuning method.
Previously preset stations This unit hasbeendisconnectedfor a long
can no longer be tuned into. period.
43
43
44
102 En
Loading ...
Loading ...
Loading ...