Loading ...
Loading ...
Loading ...
- 14
1Driver seat
2 Brake pedal
3 Drive pedal
4 Function switch
5 Steering wheel
6 Warning / control display
7 Control lever
8Parking brake
9 Engine speed lever (Diesel versions)
Engine speed potentiometer (gas versions)*
10 Display lamp (waste container flap)
11 Water dispensing, side scrubbing deck
12 Water dispensing, roller brush
The accelerator pedal can be used to drive forwards and
backwards.
If the accelerator pedal is released, the hydrostatic drive of
the vehicle is delayed or stopped.
ATTENTION
Always press the accelerator pedal carefully and slowly.
Do not jerkily change from reverse to forward drive or vice
versa.
The parking brake acts on the rear wheels and uses a
sheathed cable. If the braking power starts to decline, it can
be readjusted on the lever with a setting screw. The brake
shoes should be replaced only by Customer Service.
ATTENTION
Check the braking effect of the parking brake now and
then; the braking effect is OK if the vehicle can be stopped
on an incline of 16°.
The brake pedal activates the brake system of the rear
wheels. The correct setting of the brakes takes place auto-
matically, no adjustment work is required.
Actuation takes place hydraulically, therefore always make
sure that there is a sufficient amount of brake fluid in the
storage tank.
1 Gas withdrawal valve
Open the gas drawing valve by turning it in anti-clock-
wise direction.
ATTENTION
Ensure that the brushes are raised up.
All four control levers must be in middle position.
Do not press the accelerator pedal when starting up!
Sit on the driver's seat.
Activate parking brake.
Set motor speed to approx. 75% of the maximum
speed.
Insert the ignition key into the ignition switch.
Turn the ignition key to ignition on (position I).
Note
Diesel motor: The preglow indicator light lights up.
If the preglow indicator light goes out, turn the ignition
key to Position II (Start motor) and hold it until the motor
has started (max. 10 seconds).
Release the ignition key. The ignition key turns to position I.
At ambient temperatures below 0°C: Allow the motor to
warm up at a low motor speed before beginning work.
Note
If the motor does not start, repeat the start-up process.
6.1 Drive mode
6.1.1 Drive pedal
6.1.2 Parking brake
6.1.3 Brake pedal
6.1.4 Opening the gas supply (gas engine)
6.1.5 Start the engine
55EN
Loading ...
Loading ...
Loading ...