Loading ...
Loading ...
Loading ...
Before Setting Surface Controls (cont'd)
To Set the Cooktop Lockout Feature _COOKTOP
The clock (_ pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being accidentally
turned ON. This feature will only lock the cooktop.
iNSTRUCTiONS
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold _(_ until "CLO" (clock) appears (Figure 1). Continue
holding until a second beep sounds (after 3 seconds). If a triple beep
sounds instead, check all surface elements and turn them to the OFF
position and repeat this step. I_1will appear in the display indicating the
cooktop controls and functions are locked out until the cooktop is
unlocked (See Figure 2).
To turn the Cooktop Lockout Feature OFF:
1. Press and hold (_ until "CLO" appears (Figure 3). Continue
holding
until a second beep sounds (after 3 seconds). I_1will disappear from
the display indicating the cooktop may be used normally (Figure 4).
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop
Lockout feature. The cooktop will remain locked until the Self-Clean cycle
has completed and the oven door has unlocked. If a power failure occurs
after the Cooktop Lockout has been activated, you must turn OFF the
Cooktop Lockout feature before being able to use the cooktop features
again.
PRESS DISPLAY
(_ Figure 1
Figure 2
Figure 3
Figure 4
iiil..................
...........ii.......
How the Electronic Surface Element Controls work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that
all electronic surface element control displays show "Sb". The surface elements can be used even if the Sabbath
Feature is on.
To turn ON a Surface Element when the Oven Sabbath Feature is active:
With the Sabbath feature active, a surface element will not start heating until 15-30 seconds after you turn it on. The
heat setting you have turned to will not appear in the display because -Sb,, is showing there. Any adjustment to the
heat setting will also take 15 -30 seconds to go into effect.
To turn OFF the Surface Element when the Oven Sabbath Mode is active:
To shut off the surface element while the Sabbath feature is ON, press the ON/OFF button for that element. The
element will immediately turn off without delay.
Note: Refer to the Sabbath Feature section.
Loading ...
Loading ...
Loading ...