Lexmark MX310DN User's Guide PDF Lexmark MX310, MX317

Loading ...

This equipment may not provide for the eective hand-over of a call to another device connected to the same

line.

This equipment should not be used under any circumstances that may constitute a nuisance to other Telecom

customers.

This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for

which it is designed. Telecom will accept no responsibility should diculties arise in such circumstances.

The decadic (or pulse) dialing on this device is unsuitable for use on the Telecom network in New Zealand.

For correct operation, the total of all the Ringer Equivalence Numbers (RENs) of all parallel devices connected

to the same telephone line may not exceed 5. The REN of this device is located on the label.

This device uses an RJ-11C modular connector. Contact your point of purchase if a BT adapter is required. The

Lexmark part number is 80D1873.

Some parameters required for compliance with Telecom's telepermit requirements are dependent on the

equipment associated with this device. The associated equipment shall be set to operate within the following

limits for compliance to Telecom's speciﬁcations:

• There shall be no more than 10 call attempts to the same number within any 30 minute period for any single

manual call initiation, and

• The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt

and the beginning of the next call attempt.

• The equipment shall be set to ensure that automatic calls to

dierent

numbers are spaced such that there

is not less than 5 seconds between the end of one call attempt and the beginning of another.

Japanese telecom notice

The installed optional modem is in compliance with Japanese Telecommunication Law and has been Certiﬁed

by JATE, with Certiﬁcation Number A11-0160001.

Lexmark International, Inc.

LEX-M03-002

A11-0160001JP

Using this product in Switzerland

This product requires a Swiss billing tone ﬁlter (Lexmark part number 80D1877) to be installed on any line which

receives metering pulses in Switzerland. The ﬁlter must be used, as metering pulses are present on all analog

telephone lines in Switzerland.

Notices 247

Loading ...

Lexmark MX310DN