Loading ...
Loading ...
Loading ...
23
ALIGNMENTS AND ADJUSTMENTS
Oven Door Spring Adjustments
The oven door springs are properly adjusted before leaving the factory. The springs should
be adjusted to allow the door to remain open when pulled 90 degrees forward and yet pull
the door tight against the oven front frame when closed. If adjustments should become
necessary, remove the storage drawer and grasp spring with fingers, and pull downward.
To give more tension, push toward rear of range and attach in first slot. To make spring
adjustment on ranges without storage drawer, remove false panel and follow the same
procedure.
Make certain all surface elements are
cool and all switches are in the OFF
position prior to seating elements.
Seating Top Elements
The top element may need initial
seating after installation of the stove or
after they have been unplugged and re-
installed. Palm the element as shown.
Pick up on the rear section with your
fingers, while at the same time, push
down on the front of the element with
the palm of your hand.
Storage
Your electric range is equipped with a storage
area located beneath the oven cavity. To
access this compartment, gently lift on the
front edge of the “drop-down” panel and let it
fall forward as shown. ONLY LIFT ON THE
FRONT EDGE OF THE PANEL SO AS TO
NOT PINCH YOUR FINGERS. Do
not use this panel as a step or shelf.
Brown HeatSence™
Some models may be equipped as a Brown
HeatSense™ range with our exclusive Coil Logic
safety system. It is designed to prevent
overheating by utilizing an automatic cut-off
sensor to power off the coil element if higher than
necessary temperatures are detected. Once cooled,
these sensors will disengage, allowing power to
return to the coil element. The Coil Logic safety
sensors are visible from the top of the burner bowl
(refer to figure). When the coil elements are off
and cool, the drip pans and Coil
Logic sensors can be cleaned with mild soap and warm water. Dry thoroughly
before resuming use. Always keep all surfaces and subtop areas clean for optimal
operation. Do not use aluminum foil to line the drip pans. Improper use of aluminum
foils may result in shock or fire hazard.
Loading ...
Loading ...
Loading ...