Loading ...
Loading ...
Loading ...
21
CLEANING THE RANGE, Continued
Radiant Glass Cook Top
Before attempting to clean the glass of the radiant cook top, make sure all surfaces have cooled
down after cooking operations have been completed. When in use, a “HOT SURFACE” light
will illuminate as a helpful reminder. This light will stay illuminated for several minutes after
cooking has been completed even if controls have been turned off. Always be alert to the
presence of hot surfaces on your cooking appliance.
For normal use cleaning, we recommend using Weiman® or Cerama Bryte® glass cleaner
for the best cleaning results. Do not use harsh abrasives or rough scouring pads to attempt to
clean the glass. Permanent scratching could result.
1. Shake the container of glass cleaner well before using.
2. Apply a few drops of the cleaner cream directly to the glass surface.
3. Use a paper towel or cleaning pad designed for glass cooking surfaces to clean the entire
cook top area.
4. Use a dry cloth or paper towel to remove all cleaning residue. There is no need to rinse
with water, but be sure all cleaning residue has been removed before resuming use of the cook
top.
For heavy, burned on spillover material, a razor blade scraper can be used to very carefully
scrape off the glass as follows.
1. Allow the cook top to cool completely to room temperature.
2. Use a single edge razor blade scraper held at approximately 45° angle against the glass
surface to scrape away food residue. Do not use a dull or nicked blade to scrape away residue.
Apply only enough pressure to the scraper blade needed to dislodge and remove the food
residue.
3. After scraping with the razor, clean the glass surface with cleaner as outlined for normal
use cleaning above.
To clean the seal around the perimeter edge of the glass, wipe clean with a wet cloth. Do not
use abrasive cleansers or scraping objects to clean the glass seal.
Aluminum Foil in Oven and Broiler
Aluminum foil when used improperly is a cause of many range fires. Make certain
heating elements aren’t covered or come in contact with aluminum foil.
Never cover a rack completely. A piece of foil slightly larger than the utensil can be
placed on the rack beneath the utensil.
Backguard Control Panel or Any Painted or Aluminum Surfaces
Use a mild solution of soap and water. Do not use any harsh abrasives or cleaning
powders that may scratch or mar the surface.
Loading ...
Loading ...
Loading ...