Loading ...
Loading ...
Loading ...
14
7.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer may carry out any
repairs on electrical equipment.
► Improperly performed repairs may result in personal injury or damage to the device.
7.2 Troubleshooting table
PROBLEM SOLUTION
The device does not work There is a safety interlock switch on the container. Please ensure that the
conatiner is securely locked into position.
If the motor still will not start, check the power cord and power outlet.
Some food remains on the
disc after processing
It is normal for small pieces to remain after processing.
Motor slows down when
mixing dough
The amount of dough may have exceed the maximum capacity. Remove
half and process in two batches.
Do not add more than 18 oz dough.
Dough is too dry Let the device run and add water through feed chute, 1 tablespoon at a
time.
Dough is too wet Let the device run and add flour through feed chute, 1 tablespoon at a time.
Motor slows down when
using the chopping blade
Amount of meat may be too much. Remove half and process in two
batches.
For the best result, trim the meat of fat before processing.
Vibrates/moves during
processing
Clean and dry the rubber feet at the bottom of the unit.
Also make sure that the maximum load capacity has not been exceeded.
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
8 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for their
functionality and safety. If these were put in the non-recyclable waste or were
handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste
under any circumstances.
Loading ...
Loading ...
Loading ...