Loading ...
Loading ...
Loading ...
Display 3D LUT
Toggle this setting to ‘on’ if you want to apply a 3D LUT to your stream.
TIP Switching the ‘display 3D LUT’ setting to ‘on’ will only apply a LUT to the direct
stream output.
If you are simultaneously recording to Blackmagic RAW or ProRes video codecs while
streaming, you can use the LUT options in the record menu to add a LUT to your files,
or the monitor settings to add a LUT on the LCD or SDI outputs. Refer to the ‘record
settings’ section for more information.
Low Latency
Setting low latency to ‘on’ will ensure that there is minimum delay between what is happening
live and what is being viewed by the audience. Setting it to ‘off’ gives you more buffering so is
amore stable stream if you have an Internet connection that may be subject to drop outs or
poor connection.
Import Stream Settings
Tap the ‘import stream settings’ button to import an XML setup file that has been created so
your camera can find an ATEM Streaming Bridge on the Internet.
For more information on importing an XML setup file, refer to the ‘streaming video’ section later
in this manual.
Delete Stream Settings
Press this button to delete your camera’s imported streaming settings. You will be asked to
confirm your selection.
Setup Settings Page 10
The tenth page of the ‘setup’ tab contains your camera’s network settings.
These settings allow you to configure options such as choosing between connecting to a
network using DHCP or a static IP address.
You can connect to a network using a DHCP or a static IP address
109Settings
Loading ...
Loading ...
Loading ...