Awoco RH-WQ-36 User Manual

Loading ...

easilyoverheatandcatchonre.Theriskof

self-combustion is higher when the oil has been

used several times.

• NEVERcookon“open”amesunderthe

range hood. Check deep-fryers during use:

Superheatedoilmaybeammable.

Cleaning

WARNING

• Toreducetheriskofelectricalshock,DONOT

clean the hood while it's operating.

• Never put your hands into the area housing the

fan when the fan is operating.

Cleaning the Exterior Surfaces:

IMPORTANT

To avoid damage to the exterior surfaces:

• DO NOT use corrosive or abrasive detergent.

• DONOTusesteelwool,scoringpadorsteel

brushes. Use a paper towel or soft cloth or

nonabrasive sponge instead.

• DONOTusesaltsolutions,disinfectants,

bleaches or cleaning compound that contains

harmful chemicals.

Cleaning Method:

• Noncorrosive or nonabrasive liquid detergent

soap or all-purpose liquid cleanser.

• Wipe the surfaces with a damp paper towel or

soft cloth or nonabrasive sponge.

• Rinse with clean water.

• Wip dry with dry towel or cloth.

Note

• The nonabrasive stainless steel polisher can

be applied when done cleaning to retain the

stainless luster and grain.

• Always follow the instrunction of the polisher.

Cleaning the Stainless Steel Ba󰀪e Filters:

• Pull the spring release handle and remove the

lterbypullingitdown.

• Washthelterinthetoprackofthedishwasher

or with warm soapy solution manually.

• Lettheltersdrythoroughly.

• Make sure the spring release handle is toward

thefront,alignandinsertthelter.

• Pullthespringreleasehandleandpushthelter

into position.

• Release the handle.

• Repeatthestepsfortheremaininglters.

Replacing the Filters:

• Replacetheba󰀪eltersimmediatelyshould

they become worn out due to aging or prolonged

usage.

Replacing the LED Lamps:

WARNING

Electrical Shock Hazard

Disconnect power before servicing

Wear gloves to protect against sharp edges

• Thisrangehooduses12V,3WLED.

• Unplugtherangehood,orturno󰀨thebreaker.

• RemovetheBa󰀪eFilteradjacenttotheLamp.

• Reach into the Hood Unit and push the Lamp

out from the inside of the Hood Unit.

• Disconnect the wires.

• Connect the wires to the new Lamp.

• Align and put the new Lamp back into position.

• Press the edge of the new Lamp until it touches

the bottom of the Hood Unit.

• PuttheBa󰀪eFilterbackintoplace.

• Plugintherangehood,orturnonthebreaker.

• Check if the new Lamp is working properly.

Range Hood Care

Reach into the Hood

Push the lamp out

Loading ...

Awoco RH-WQ-36 Island Mount 43”H Stainless Steel Range Hood 4 Speeds, 6” Round Top Vent 900CFM 4 LED Lights & Remote Control 36” Island Mount

User Manual - Page 13