Loading ...
Loading ...
Loading ...
33
5. CLI Commands
show retry
Use the show retry command to display the retry value entered for the AutoProbe entry.
Syntax
show retry
Examples
The following command displays the retry value of entry “probe ABC”:
console> probe (probe ABC)> show retry
2
autoprobe: secondary
secondary address
Use the secondary address command to set the IP address of the second network device that the AutoProbe entry will
probe. Both IPv4 and IPv6 addresses are supported.
Syntax
secondary address <ip-address>
• ip-address – Specifies the IPv4 or IPv6 address of the second network device that the entry will probe.
Examples
The following command specifies “172.17.77.89” as the secondary IP address for entry “SnmpProbe”:
console> probe (SnmpProbe)> secondary address 172.17.77.89
Update complete
secondary oid
Use the secondary oid command to set the secondary SNMP OID that the AutoProbe entry will probe. This command applies
only to SNMP probes.
Syntax
secondary oid <oid>
• oid – Specifies the secondary OID that the entry will use for probe tests.
Examples
The following command specifies “1.3.6.1.2.1.1.3.1” as the secondary OID to use for entry “SnmpProbe”:
console> probe (SnmpProbe)> secondary oid 1.3.6.1.2.1.1.3.1
Update complete
Loading ...
Loading ...
Loading ...