Loading ...
Loading ...
Loading ...
22
Troubleshooting:
Fault Probable Cause Solution
Water changes color
or becomes cloudy.
Rower is in direct
sunlight or has not
had water treat-
ment.
Local tap water is
of poor quality.
Change rower location to reduce
direct exposure to sunlight. Add
water treatment or change tank
water as directed in the water
treatment section of this manual.
Consider using distilled water to refill
tank.
Rower Belt slipping
off belt/ bungee
pulley.
Bungee not under
enough tension.
Recoil not strong
enough
Tighten bungee cord following the
instructions in "reattaching the rower
belt" section of this manual.
Inconsistent
readings on the
Rower Computer for
500meter split time
and SPM (strokes
per minute).
Sensor gap
Faulty Sensor
Sensor has moved
out of position
Wiring harness
Use the back cover of the computer
as a “Gap tool” to check the gap
between sensor head and Magnetic
ring, or see if the Sensor head has
moved out of position.
Please contact your nearest FDF
customer service center for details
The Rower
Computer does not
illuminate after
battery installation.
Batteries installed
incorrectly or need
replacing.
Replace/reinstall batteries in correct
position and try again. If the LCD
screen fails to illuminate, try rotating
the batteries slightly in the computer.
If this fails, contact your local service
center.
The Rower
Computer screen
illuminates, but does
not register when
rowing.
Loose or failed
connection.
Sensor gap too
wide
Check that the computer lead is
connected properly. If it is
connected then contact your local
service center. Check Sensor gap
Loading ...