OWON SDS7072E 70MHz 2Ch Digital Oscilloscope

Manual - Page 73

For SDS7072E.

PDF File Manual, 106 pages, Read Online | Download pdf file

SDS7072E photo
Loading ...
Loading ...
Loading ...
5.Advanced User Guidebook
68
LAN Set
Using the LAN port, the oscilloscope can be connected with a computer directly, or
through the router to connect. The network parameters can be set in the menu below.
Refer to "Using LAN Port" on P82 for the operation steps.
Press the Utility button and turn the M knob to select the LAN Set to go to the following
menu.
Figure 5-66 LAN Set menu
The description of LAN Set menu is shown as the follows:
How to Measure Automatically
Press the Measure button to display the menu for the settings of the Automatic
Measurements. At most 8 types of measurements could be displayed on the bottom left
of the screen.
The oscilloscopes provide 24 parameters for auto measurement, including Period, Freq,
Mean, PK-PK, RMS, Max, Min, Vtop, Vbase, Vamp, OverShoot, PreShoot, Rise Time,
Fall Time, +D width, -D width, +Duty, -Duty, Delay A→B , Delay A→B , Cycle
RMS, Cursor RMS, Duty cycle, and Phase.
The menu is displayed as Figure 5-67.
Function
Menu
Setting Description
Set
IP
Press F1 button to switch between each byte, turn the M knob
to change value (0 - 255)
Port
Turn the M knob to change value (0 - 4000)
Netgate
Press F3 button to switch between each byte, turn the M knob
to change value (0 - 255)
Phy addr
Press F4 button to switch between each byte, turn the M knob
to change value (0 - FF)
Net mask
Press F5 button to switch between each byte, turn the M knob
to change value (0 - 255)
Save set
Save the current settings and prompt "reset to update the config"
Loading ...
Loading ...
Loading ...