100250 User Manual

Loading ...

CONSOLE SERVICE MODE

TheConsoleServiceModeletsyousettheunitsofmeasurementtoeitherEnglishorMetric,seethetotaltimeand

distancethemachinehasbeenused,adjustthealtitudevalueforamoreaccuratecaloriecount,orndoutwhichversion

of Firmware is installed.

1. Hold down the Increase button and Decrease button together for 3 seconds while in the Idle Mode to go into the Con-

sole Service Mode.

2. The Console display shows the Units prompt ( “Unit” ). Push START/STOP to start Units option. Push the Increase/

Decreasebuttonstochangebetween“M”(ImperialEnglishunits)and“KM”(metricunits).

3. PushSTART/STOPtoset.Forthenextoption,pushtheIncreasebutton.

4. The Console display shows the Workout Statistics prompt ( “StAt” ). Push START/STOP to start the Workout Statistics

option. The Console will display the Total Distance ( “Odo” ) and Total Time.

Note: The upper displayed value is total hours followed by the remaining minutes.

5. PushSTART/STOPtoexit.Forthenextoption,pushtheIncreasebutton.

6. TheConsoledisplayshowstheFirmwareVersionprompt(“Fir”).TheConsolewilldisplaywhichFirmwareVersionis

installedintheSpeeddisplayeld.

7. Forthenextoption,pushtheIncreasebutton.

8. TheConsoledisplayshowsAltitude(“Alt”)withthepreviouslyenteredvalueintheSpeeddisplayeld.PushSTART/

STOP to adjust the Altitude value. Use the Increase/Decrease buttons to change the value.

9. PushSTART/STOPtoexit.Forthenextoption,pushtheIncreasebutton.

10. TheConsoledisplayshowstheexitprompt(“dOnE”).

11. PushSTART/STOPtoexit.

TofullyexittheConsoleServiceModepushandholddowntheSTART/STOPbuttonfor3seconds.InServiceModeifthe

Consoledoesnotreceiveanyinputinapproximately5minutes,itgoesintoSleepMode.

Loading ...

User Manual - Page 20