Loading ...
Loading ...
Loading ...
mnstaaiation mnstructions
[] iNSTALL THE ANTbTJP DEVICE
[]
For wood construction, drill a pilot hole
at an angle of 20 ° from the horizontal.
A nail or awt may be used if a dritt is not
available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction,
you will need a 1/4" x 11/2" lag bolt and
a 1/2" O.D. sleeve anchor, which are not
provided. Drill the recommended size
hole for the hardware.
Wallboard Back of
range
screw
[]
tnstatt the sleeve anchor into the drilled
hole and then install the tag bolt through
the device. The bolts must be properly
tightened as recommended for the
hardware.
Slide the range against the wall, and
check for proper installation by grasping
the front edge of the cooktop and
carefully attempting to tilt the range
forward.
WHEN ALL HOOKUPS ARE
Make sure aH controls are melt in the OFF
position. Make sure the flow of combustion
and ventilation air to the range is
unobstructed.
CONVERT TO LP GAS (or convert back
to naturam gas from LP)
This range meaves the faetorv set for use
with natural gas. mfVou want to convert to
LP gas, the conversion must be performed
bv a qualified LP gas installer.
The conversion instructions and LP orifices
can be found attached to the range next to
the pressure regulator.
Keep these instructions and the orifices in
case you want to convert back to natural gas.
39
Loading ...
Loading ...
Loading ...