Loading ...
Loading ...
Loading ...
LEVELIHG THE RANGE
1. Install the oven Raise
shelves in the oven range//
and position the
range where it will
be installed.
2. Check for
levelness by placing a
spirit level or a cup,
partially filled with
water, on one of the
oven shelves. If using
aspirit level, take two
readings--with the
level placed diagonally
first in one direction
and then the other.
3. Remove the
storage drawer,
broiler drawer or
kick panel. The front
leveling legs can be
adjusted from the
bottom and the rear
legs can be adjusted
_ ower
range
(on some models)
Lower
range
Leg _ S
leveler
Raise
range
(on some models)
from the top or bottom.
4. Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
5. After the range is level, slide the range
away from the wall so that the Anti-Tip device
can be installed.
INSTALLING THE ANTI-TIP DEVICE
WARNING:
•Range MUST be secured with an
approved Anti-Tip device.
• Unless properly installed, the range
could be tipped by you or a child standing,
sitting or leaning on an open door.
•After installing the Anti-Tip device, verify
that it is in place by carefully attempting to
tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
•The use of this device does not preclude
tipping of the range when not properly
installed.
•If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
.__._/_j_ _ Anti-Tip I
Slotted _ ev'ce I
head ___._. It F----------+_____
screw _' Wallplate ,,
Approx.20 ° " /_
J _
,,,_., z pt / /Marked edge
J _ n/8 // of range
2. Locate the outside edge of the device 21A"
toward the center of the range from the marked
edge of the range.
3. Using the device as a template, marl{ the
position of the hole for the screw.
4. For wood construction, drill apilot hole at an
angle of 20 degrees from the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
(continued next page)
40
Loading ...
Loading ...
Loading ...