Loading ...
Loading ...
Loading ...
CARE AND CLEANING
(continued)
I CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS
(IF SO EQUIPPED) IN PLACE.
Sealed Burner Assemblies (on some models)
Grate
Burner cap
Burner Heads (on sealed bumers only)
NOTE: Before removing the burner heads and
caps, remember their size and location. Replace
them in the same location after cleaning.
Drip pan
(on some models)
Burner head
Electrode
Turn all controls OFF before removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and drip
pans (if so equipped) can be lifted off, making
them easy to clean.
The electrode of
the spark igniter is
exposed when the
burner head is
removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An
electric shock may result, which could cause
you to knock over hot cookware.
For proper ignition,
make sure the small
hole in the section that
fits over the electrode
is kept open. A sewing
needle or wire twist-tie
works well to unclog it.
The slits in the burner beads of your range
nlust be kept clean at all times for an even,
unhampered flame.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog
these openings.
To remove burned-on food, soak the bumer heads
in a solution of mild liquid detergent and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before putting the
burner head back,
shake out excess
water and then dry it
thoroughly by setting
it in a warm oven for
30 minutes. 8
After cleaning, make sure
the slot in the burner head is
positioned over the electrode.
Replace the burner
heads and caps. Make
sure that the heads and
caps are replaced in the correct location. There is
one small, 2 medium and one large head and cap.
NOTE: On some models the bumer heads and caps
are all the same size and can be used in any of the
4 needed locations.
Burner Caps (on sealed bumers only)
Lift off when cool. Wash bumer caps in hot, soapy
water and rinse with clean water. You may scour with
a plastic scouring pad to remove burned-on food
particles.
Dry them in a warm oven or with a cloth--don't
reassemble them wet. Replace the burner caps.
Make sure that caps are replaced on the correct size
bumer. There is one small, 2 medium and one large cap.
22
small
medium
large
medium i-_
medium I_ _
small
large
Front of Range
NOTE: On some models the caps are all the same
size and can be used in any of the 4 needed locations.
Loading ...
Loading ...
Loading ...