Loading ...
Loading ...
Loading ...
– 7
Illustration
Install the fresh water reservoir. Insert the bot-
tom part first and then press toward the top on the
motor compartment to check if it is locked in.
Illustration
Attach the suction hose and the spray hose to the
connectors on the appliance.
Note
: Press the suction hose tightly into the connector
to lock it into place.
Illustration
Connect the spray/suction pipes and attach to the
handle. Center the locking lever when attaching it,
turn clockwise to lock.
Attach the floor nozzle to the spray/suction pipes
and secure with locking lever.
The appliance is now prepared for wet cleaning.
몇 CAUTION
Always work with an inserted foam filter - during
wet as well as dry vacuum cleaning!
몇 CAUTION
Check the object to be cleaned prior to using the appli-
ance in an inconspicuous place for colour fastness and
water resistance.
Do not clean water-sensitive floor coverings such
as
w
ood floors (the moisture could penetrate and damage
the floor).
NOTICE
Warm water (max. 50°C) will increase the cleaning ef-
fect.
Use the wash floor nozzle.
Work without the hard surface insert.
Please only use the carpet cleaner RM 519.
Use the wash floor nozzle.
Slide the attachment for hard surfaces onto the
spray ex floor nozzle from the side. The bristles
should point towards the back.
Use the wash hand nozzle.
Note: You can remove the water reservoir to fill it or you
can fill it directly on the appliance.
Illustration
Flip the reservoir cover up.
Add 100 - 200 ml (volume depends on degree of
contamination) of RM 519 into the fresh water res-
ervoir, then add tap water - do not overfill.
Close the reservoir cover.
Illustration
Insert the mains plug into the socket.
Press the switch for suction (position I), suction tur-
bine is running.
Illustration
Close fully the surrounding air separator at the han-
dle.
Illustration
Press the switch for spraying (position I), the deter-
gent pump is ready.
Illustration
Use the lever on the spray handle to spray on de-
tergent solution.
Illustration
For continuous spray, the spray lever can be
locked; for this, activate the spray lever and pull the
locking key toward the rear.
Run across the surface to be cleaned in overlap-
ping paths. Pull the nozzle backwards (do not
push).
Note: If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
Switch the appliance off by pressing the switch for
suction and spraying (position 0).
Separate the spray/suction hose and the spr
ay
ho
se from the appliance.
Note: Possibly remaining water can drip out, there-
fore you should place these into the shower or
bathtub.
Remove the accessories and the fresh water reser-
voir and unlatch the motor casing.
Remove the motor casing and empty the reservoir.
–
Always work from the light to the shade (from the
window to the door).
– Always work from the cleaned to the uncleaned
surface.
– Rugs with jute backing can shrink if too much water
is used and can bleed colours.
– Brush high-fiber rugs in the direction of the weave
after cleaning (using a fiber brush or a scrubber).
– Water-proofing the fabric using Care Tex RM 762
after the wet cleaning prevents a quick resoiling of
the textile surface.
– Do not step on cleaned surfaces until they have
dried and do not place furniture on them to avoid
pressure spots or rust stains.
Turn on suction and spraying (position I).
Spray and simultaneously suction off detergent so-
lution in one work cycle.
Switch off the spray switch and suction off the re-
maining cleaning solution.
After cleaning the carpets, reclean them using
clear, warm water and waterproof if needed.
Switch on sprayer (position I).
Apply detergent solution and allow to react for 5
minutes (vacuuming is switched off).
Clean the surface just like you would with light/nor-
mal soiling.
After cleaning the carpets, reclean them using
clear, warm water and waterproof if needed.
Operations
Wet cleaning
carpets/hard floors/upholstery
Wet cleaning of carpeted floors
Wet cleaning of hard surfaces
Wet cleaning of upholstery
Fill up fresh water reservoir
Start working
Emptying the reservoir during operation
Cleaning tips/mode of operation
Cleaning methods
Light/normal contamination
Heavy soiling or stains
12 EN
Loading ...
Loading ...
Loading ...