Loading ...
Loading ...
Loading ...
DW089/DW089CG
16
E
OPERATION
To Turn the Laser On and Off (fig. 1)
With the laser off, place it on aflat surface. This model has three
ON/OFF buttons, one for ahorizontal laser line (c), one for avertical
laser line (d) and one for aside vertical laser line (e). Each laser line is
powered on by pressing its ON/OFF button. The laser lines can be
powered one at atime or at the same time. Pressing the ON/OFF
buttons again turns the laser lines off.
Using the Laser
The beams are level or plumb as long as the calibration has been
checked (see Field Calibration Check) and the laser beam is not
flashing (see Out of Tilt Range Indicator).
OUT OF TILT RANGE INDICATOR (FIG. 2)
The DW089/DW089CG laser is designed to self-level. If the laser has
been tilted so much that it cannot level itself (average > 4° tilt), it will
flash the laser beam. The flashing beam indicates the tilt range has
been exceeded and IS NOT LEVEL (OR PLUMB) AND SHOULD NOT
BE USED FOR DETERMINING OR MARKING LEVEL (OR PLUMB). Try
repositioning the laser on amore level surface.
SLOPING THE LASER
If the DW089/DW089CG laser is tilted beyond 15° out of level, its laser
beams will stay on longer between flashes to make it easier to do
angled work.
USING THE PIVOT BRACKET (FIG. 1)
The DW089/DW089CG laser has amagnetic pivot bracket (f)
permanently attached to the unit. This bracket allows the unit to
be mounted to any upright surface made of steel or iron. Common
examples of suitable surfaces include steel framing studs, steel door
frames, and structural steel beams. The bracket also has akeyhole
slot (g) allowing the unit to be hung from anail or screw on any kind of
surface.
DW089_DW089CG - User Manual - NA - May 2018.indd 16 5/25/2018 10:40:48 AM
Loading ...
Loading ...
Loading ...