Loading ...
Loading ...
Loading ...
78 - INSTALLATION 91477A046/A
6. Refit the cover. Ensure the moulded part of
the glass (A) is facing the door.
7. Press the cover completely down so that it
attaches perfectly to the bulb support.
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
INSTALLATION
Electrical connection
General information
Check the mains characteristics against the data
indicated on the plate.
The identification plate bearing the technical
data, serial number and brand name is visibly
positioned on the appliance.
Do not remove this plate for any reason.
The appliance must be connected to ground
using a wire that is at least 20 mm longer than
the other wires.
The appliance can work in the following modes:
Fixed connection
Fit the power line with an all-pole circuit breaker
with a contact separation distance sufficient to
provide complete disconnection in category III
overvoltage conditions, pursuant to installation
regulations.
For the Australian/New Zealand market:
The circuit breaker incorporated in the fixed
connection must comply with AS/NZS 3000.
Cable replacement
1. Unscrew the rear casing screws and remove
the casing to access the terminal board.
2. Remove the screw of the cable clamp.
3. Replace the cable.
See General safety instructions.
220-240 V 1N~
3 x 2.5 mm ²
three-core cable
380-415 V 2N~
4 x 1.5 mm ²
four-core cable
The values indicated refer to the cross-
section of the internal lead.
The power cables are sized taking into
account the coincidence factor (in
compliance with standard EN 60335-
2-6).
Power voltage
Danger of electrocution
• Disconnect the mains power supply.
Loading ...
Loading ...
Loading ...