Loading ...
Loading ...
Loading ...
3. Secure the deck chute by tightening the wing knobs removed earlier. See
Figure 11.
1
2
Figure 11
Installing the Mulch Plug
WARNING
NEVER operate this tractor without either the mulch plug or deck chute
installed.
1. Remove the wing knobs installed on the mowing deck and retain for later
installation. See Figure 12.
1
2
Figure 12
2. Install the mulch plug into the deck discharge opening on the deck. The rear
of the mulch plug should be under the tab on the rear deck bracket. The
studs on the deck surface will fit through the holes on the upper portion of
the mulch plug. The small tab on the deck lip area will fit through the square
cutout on the lower portion of the mulch plug. See Figure 12.
Note: Make certain that the upper-rear portion of mulch plug is depressing
the safety switch located on the deck surface and under the tab on the rear
deck bracket. The engine will not start without the mulch plug properly in
place.
3. Secure the mulch plug by tightening the wing knobs removed in step 1.
Install The Rear Engine Cover
1. Remove the two factory installed hex screws located on the rear engine
cover mounting bracket. Retain the screws for later instructions. See
Figure 13.
2. Install the rear engine cover by positioning it in place as shown in Figure 13.
Tip the engine cover forward to fit it into the slots provided, then rotate it
backwards to align the mounting holes.
Figure 13
3. Secure the cover with the two hex screws previously removed. Do not to
over-tighten.
Installing the Bumper
1. Remove the two screws as shown in Figure 14.
2. Position the bumper over the mounting holes and secure using the hardware
removed in Step 1, as shown in Figure 14.
Figure 14
12
ASSEMBLY
Loading ...
Loading ...
Loading ...