Loading ...
Loading ...
Loading ...
4. Lower the steering wheel assembly onto the lower steering shaft (1) and
secure with bolt and lock nut (2) previously removed. See Figure 2.
1
2
2
Figure 3
5. Tighten the shoulder bolt and lock nut using a 9/16” wrench and
7/16”wrench or socket.
6. Remove the pedestal cap mount screw factory installed and located on the
tractor’s steering console. Retain the screw for later instructions.
7. Slide the Pedestal cap down onto the tractor (1) and slightly rotate to the
right to clip into place. Secure the pedestal with the screw (2) previously
removed. See Figure 4.
1
2
Figure 4
Attaching The Seat
If the seat for your tractor was not attached at the factory, follow the applicable
instructions below to attach it.
1. Remove the shoulder bolts and lock nuts from the seat mounting bracket
included in your hardware pack. See Figure 5.
Figure 5
2. Remove the two self-tapping screws factory installed on the tractor. See
Figure 6.
Figure 6
3. Align the seat bracket in place over the holes from where the self-tapping
screws were removed, as shown in Figure 7.
4. Using a /-inch drive ratchet with a /” socket, secure the seat bracket with
the self-tapping screws removed in Step 2. See Figure 7.
Figure 7
CAUTION
Do not use any type of power tool (e.g. impact gun or electric drill with nut
driver attached) when tightening the self-tapping bolts to attach the seat
bracket.
5. Position the seat assembly over the seat mounting bracket, aligning the
holes provided.
10
ASSEMBLY
Loading ...
Loading ...
Loading ...