Loading ...
Loading ...
Loading ...
15
ENG
This hob must be connected to the power supply only by a suitably qualified person.
Before connecting the hob to the power supply, check that:
1.The domestic wiring system is suitable for the power drawn by the hob.
2.The voltage corresponds to the value given in the rating plate
3.The power supply cable sections can withstand the load specified on the rating plate.
To connect the hob to the power supply, do not use adapters, reducers, or branching devices, as they can cause
overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its temperature will not exceed
75˚C at any point.
Check with an electrician whether the domestic wiring system is suitable without alterations.
Any alterations must only be made by a qualified electrician.
The power supply should be connected in compliance with the relevant standard, or a single-pole circuit breaker. The method of
connection is shown below.
1. The induction hotplate must be installed by qualified personnel or technicians. We have professionals at your service. Please
never conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as the humidity
may damage the hob electronics
3. The induction hotplate should be installed so that better heat radiation can be ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface should withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
Cautions
Connecting the hob to the mains power supply
Green/Yellow
Brown
Blue
• If the cable is damaged or to be replaced, the operation must be carried out the by after-sale agent with dedicated tools to
avoid any accidents.
• If the appliance is being connected directly to the mains an Omni polar circuit-breaker must be installed with a minimum
opening of 3mm between contacts.
• The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and replaced by authorized technicians only.
• The yellow/green wire of the power supply cable must be connected to the earth of both power supply and appliance
terminals.
• The manufacturer cannot be held responsible for any accidents resulting from the use of an appliance which is not grounded,
or with faulty earth connection continuity.
• If the appliance has a socket outlet, it must be installed so that the socket outlet is accessible.
The bottom surface and the power cord of the hob are not accessible after installation.
Loading ...
Loading ...
Loading ...