Loading ...
Loading ...
Loading ...
lain Burner Instructions
Lighting The Hain Burners With Push And
Turn Ignition
1. Before each use, check all hoses for cracks,
nicks, cuts, or abrasions. If ahose is
damaged in any way, do not use your grill
before replacing the hose with an authorized
part from the Parts List. Also make sure all
gas supply connections are securely
tightened.
2. Familiarize yourself with the Safety and Use
and Care instructions in this manual. Do not
smoke while lighting the grill or checking gas
supply connections.
3. Be sure the LP gas tank has gas.
4. Open the grill lid.
5. Check that the end of each burner tube is
properly located over each valve orifice.
Failure to replace afaulty hose, secure gas
supply connections, or to open the lid
before proceeding to the Lighting
Procedures could result in a fire or
explosion that could cause serious bodily
injury, death, or property damage.
6. Set Control Knobs to OFF and open the LP
gas tank valve SLOWLY or turn on the
natural gas. i
OFF
HI/LIGHT
7.
LOW
Push in the burner control knob of the
burner you wish to light and turn left to
"HI/LIGHT". You will hear a click as a spark is
sent to the burner. If the burner does not
light, then turn back to "OFF, and repeat
this procedure. Continue this process until
the burner lights. i
HI/LIGHT
OFF
LOW
Side Burner and Back Burner
Lighting Instructions
Lighting The Side Burner Or Back
Burner With Electronic Ignition
Follow steps 1 through 5 of the Grill Lighting
Instructions.
1. Open side burner or grill lid.
2. Set control knobs to OFF and open the LP
gas tank valve SLOWLY or turn on the
natural gas.
3. Push and turn the side or back burner
control knob to "HI/LIGHT".
4. Immediately press the electric igniter
button for 3-5 seconds to light the burner.
You should hear a clicking sound which
shows the electronic ignition is working.
If the burner does not light within 5
seconds, turn the burner control knob to
"Off". Wait 5 minutes for the gas to
clear, and repeat the above procedure.
6. For the back burner, continue to push and
hold the burner control knob in for 5 to 7
seconds after the burner lights until the
flame sensor begins operating. Letting up
on the burner control knob before a high
enough temperature has been reached
may cause the flame sensor to shut off
fuel to the back burner.
Side burner
Electronic ignition
Back burner
Main burners
II
8. When lit, turn the burner control knob to its
desired heat setting.
23
Loading ...
Loading ...
Loading ...