Loading ...
Loading ...
Loading ...
Flow Limiting Valves on LP Gas Tanks
Your LP gas tank is equipped with a flow limiting
valve that wilt restrict the flow of gas due to a
sudden change in pressure. This can often
activate without your knowledge. You will notice
among olher things that your grtl does not get as
hot as it should, witl take longer to heat up or
you may not be able to light all burners. If you
notice any of the above, then you should reset
the valve and clear' your gas _ine
?b do this
;_ Ensure the LP gas tank valve is OFR
2 Disconnect the regulator from the LP gas
tank.
3. Open aH burnercontrot knobs including the
side burner to Hi/Light at the same time.
4_ Close all burner control knobs to OFR
5. Let the LP gas tank stand for at _east _0
minutes,
6_ Reconnect the regulator assemUy to the LP
gas Lank
7. Slowly, meaning about 1/4 turn at a Lime,
bJm on the LP gas valve.
8. Follow the burner lighting procedures to
light the burner farthest away from the gas
source
9. ]he flow limiting valve should now be reset
This flow limiting Valve is triggered by sudden
changes in pressure This can be caused by a leak,
faulb/connection of the regulator to t_e LP gas
tank, turning on the LP gas tank valve too quickly,
or turning the burners off by turning the LP gas
tank valve off before turning the burner control
knobs to offl Note: aJways turn off your burners
using the burner contro! knobs first before turning
the LP gas tank valve off.
Transportation and Storage
l. "Place a dust cap on the cylindel vave outlet
whenever the cylinder is not in use. Only
install the type of dust cap on the cylinder
valve outiet that is provided wth the
cylinder of propane valve. Other types of
caps or plugs may result in leakage.
2. Always transport your cylinder in an upright
position,
3, Do not smoke whe_ transporting your
Check aH connections for LP Gas _eaks
DNever test for leaks with a fiame_ Prior to
first use, at the beginning of each season
or every time your LP Gas tank is changed
you must check for gas teaks. Follow
these three steps:
Hakea soap solut on by mixingo e part
liquid detergent and one part water
D
D
[urn the burner contro_ knobs to tse OFF
position Then turn the gas ON at the source.
Appty the soap sotution to aH gas :onnections
indicated by the arrows. See diag am. _f
bubbles appear in the soap solution the
connections are not properly sealed Check
each fitting and tighten or repair as
necessary
:ff you have a gas leak that cannot be repaired
by tightening turn off the gas at the
source, disconnect fuel line from yot. r grill
and call 1-800_4_Hyo.HOHE@ or yo/.. °
gas supplier for- repar ass stance.
Disconnecting A Liquid Propa_e Gas (LPG}
Tank From Your Grill
_} Hake sure the burner valves and .P gas
tank valve are of£ (Turn clockwise
[Z Detach the hose and regulator ass(;mMy
from the LP gas taJ'_k valve by turr ng the
quick coupling nut counterc ockwise
Loading ...
Loading ...
Loading ...