Loading ...
Loading ...
Loading ...
26 English
Replacing the dust filter
DANGER
Health risk from dust
Wear a dust mark and safety goggles when working on the filter
system.
1 Locks (2x)
2 Dust filter (flat filter)
3 Filter box
1. Switch off the device and remove the key from the key-operat-
ed switch.
2. Operate the manual dust filter cleaning.
3. Open the locks.
4. Lower the filter box with the dust filter down to the end stop.
5. Remove the dust filter upwards.
6. Check the dust filter.
a Clean it by vacuuming off dirt or tapping off carefully.
b Use a new dust filter if it is damaged or heavily soiled.
ATTENTION
Risk of damage to the dust filter.
When closing the filter box, make sure that the dust filter is cor-
rectly inserted into the filter box. All 4 corners of the dust filter
must be flush with the filter box.
Replacing / setting the sealing strips
Note
The trailing distance of the front and rear sealing strip defines
how much the sealing lip folds backwards when driving the de-
vice forwards.
When set correctly, there must be a gap between the side sealing
strips and the floor.
1 Fastening
2 Side sealing strip
3 Front sealing strip
4 Rear sealing strip
1. Unfasten the fastening of the sealing strips.
2. Set the sealing strip by shifting it in the elongated holes.
a Refer to the table for the values.
3. Once the settings are correct, fasten the sealing strips.
Fuses
Check the fuses
1 Main fuse
2 Fuse
1. Open the cover.
2. Replace the defective fuse only with a fuse of the same fuse
rating.
3. The device is ready for use when the main breaker is
down.
4. If the main breaker is up, the breaker has triggered
and the device is not ready for operation. Press the
breaker.
If the main breaker triggers repeatedly, the cause must
be checked. In this case contact Customer Service.
Sealing strips Setting values
Side sealing strips Distance from ground 1 - -2 mm
Front sealing strip Trailing distance 10-15 mm
Rear sealing strip Trailing distance 5-10 mm
Loading ...
Loading ...
Loading ...