Loading ...
Loading ...
Loading ...
8
Assembly
2 Attach the Chassis Support Bracket
To avoid possible SERIOUS INJURY to finger from moving door operator:
l
ALWAYS keep hand clear of sprocket while operating operator.
l
Securely attach sprocket cover BEFORE operating.
1. Position the chassis support bracket on the unit.
2. Attach the bracket to the rail with 1/4"-20 x 5/8" hex bolts and lock washers. Do not overtighten.
3. Attach the bracket to the operator by inserting a 5/16"-18 x 1/2" washered screw through a hole in each
side flange and a matching hole in the bracket. Complete the connection by inserting the #8-32 x 3/8"
screw through the back flange and the hole in rail support.
HARDWARE
Washered Bolt
5/16"-18x1/2"
Screw
#8-32x3/8"
Washered Bolt
5/16"-18x1/2"
Screw
#8-32x3/8"
Hex Bolt 1/4"-20x5/8"
Lock
Washer
3 Tighten the Chain
1. Loosen the inner nut and lock washer on the trolley threaded shaft.
2. Tighten the outer nut until the chain is a 1/2 inch above the base of the rail at the midpoint of the rail.
3. Re-tighten the inner nut.
Slack in the chain is normal when the door is closed. No readjustment is necessary.
Sprocket noise can result if the chain is too loose. During future maintenance, ALWAYS pull the emergency release
handle to disconnect the trolley before adjusting the chain.
1/2" (13 mm)
Loading ...
Loading ...
Loading ...