Loading ...
Loading ...
Loading ...
13
OPERATION
B1
B2
D2
D1
A
B
C
E
F
G
H
I
Figure 14
A. LAPBAR DRIVE CONTROL LEVERS
The RH (Right Hand) and LH (Left Hand) lapbar drive control
levers are located on each side of the operator’s seat. The hinged
levers pivot outward to permit the operator to sit in the seat,
or dismount. To start the tractor, the lapbar drive control levers
must be fully out and in park position.
Each drive control lever controls the respective motor.
Consequently, these levers control all of the tractors movement.
Driving and steering using these control levers is quite different
from a conventional tractor and will take practice to master.
Refer to Practice Operation section for further instructions.
B. DECK LIFT
Deck Lift Pedal - The deck lift pedal is located on the front,
right corner of the platform. The pedal is used in conjunction
with the deck lift knob or 8 position magnetic pin (if
equipped) to raise and lower the mowing deck.
1. Deck Height Index Knob (If Equipped) - Each rotation
represents a ⁄” (6.35 mm) change in deck height.
Positions range from 1” (2.5 cm) to 4-½” (11.4 cm) at the
highest point. Push forward on the deck lift pedal, rotate
the deck height index knob to the desired height and
release the deck lift pedal.
2. 8 Position Magnetic Pin (If equipped) - The 8 position
magnetic pin is used in conjunction with the deck lift
pedal to raise and lower the mowing deck. Push forward
on the deck lift pedal, place the 8 position magnetic pin in
the desired height and release the deck lift pedal.
NOTE: Amount of deck height change is dependent on
depth of deck lift pedal press. The more height change
needed, the more the deck lift pedal should be pushed
forward.
Loading ...
Loading ...
Loading ...