Loading ...
Loading ...
Loading ...
10
ASSEMBLY
3. If necessary, securely connect the seat switch wiring harness
(a) to the seat switch (b) (Figure 5). Secure excess wire away
from pinch points before continuing.
a
a
b
b
Figure 5
NOTE: The tractor will not operate without the seat switch wiring
harness connected.
Position Lapbar Drive Control Levers
The lapbar drive control levers can be adjusted up/down and
forward/backward for the operator’s comfort. Three height
positions are available and/or levers can be rotated forward or
rearward using the knob.
TO ADJUST THE LAPBAR DRIVE CONTROL LEVER HEIGHT:
1. Remove the two carriage screws (a) and two flange lock nuts
(b) that secure the lapbar drive control lever (c) to the upper
handle adjuster (d) (Figure 6).
NOTE: The multi-tool (if equipped) can be used to make this
adjustment. Refer to Multi-Tool (If equipped) on page 14.
2. Move the lapbar drive control lever into one of the three
available heights and secure in place with the carriage screws
and flange lock nuts (Figure 6).
c
a
a
b
b
d
Figure 6
TO ADJUST THE LAPBAR DRIVE CONTROL LEVERS
FORWARD/REARWARD:
1. Rotate the knob (a) counter-clockwise to loosen the knob (a)
(Figure 7).
2. Lift and rotate the lapbar drive control lever into the desired
position.
3. Rotate the knob clockwise to secure the lapbar drive control
lever into position (Figure 7).
a
a
Figure 7
4. If the lapbars do not line up after making the knob
adjustment, loosen nuts (b), align lapbars and retighten nuts.
Once this fine adjustment is made, the lapbars will align
when using the knob adjustment (Figure 7).
Lower Discharge Chute Deflector
WARNING
Never operate the cutting deck without the chute
deflector installed and in the down position.
ATTACHING THE CHUTE DEFLECTOR IF NECESSARY
1. If necessary, remove the keys attached with a zip tie to the
chute bracket.
2. Align the two chute deflector mounting holes (a) with the to
deck mounting holes (b).
3. Using two carriage bolts (c) and two flange nuts (d), secure
the chute deflector to the deck (Figure 8). Tighten to 170-200
in-lbs (18.5-23 N-m) (Figure 8). Skip ahead to Setting Deck
Wheels.
d
a
c
b
Figure 8
Loading ...
Loading ...
Loading ...