Loading ...
Loading ...
Loading ...
14
FINAL INSTALLATION
3. Partially insert three blade screws (BB) along with three
blade washers (CC) through one blade (M) and into one
blade arm (L). Tighten each blade screw (BB) with a
Phillips screwdriver (not included), starting with the one
in the middle. Repeat this step for the remaining blades
(M) and blade arms (L).
Hardware Used
BB
Blade Screw x 15
CC
Blade Washer x 15
4. Install the blade arm (L) to the underside of the motor
assembly (I) with motor screws (O) previously removed
(Step 6, page 8). Tighten with Phillips screwdriver (not
included). Note: The notch in the tter plate allows
a Phillips screwdriver (not included) access to motor
screws (O).
Repeat for each blade arm (L).
5. Remove the tter plate screws (S) preassembled to the
tter plate (J). Then, connect the 9-pin connectors from
the tter plate (J) and the light kit (G).
3
4
5
BB
CC
M
L
I
O
L
G
J
S
9-pin Connector
Notch
Loading ...
Loading ...
Loading ...