Loading ...
Loading ...
Loading ...
10
STANDARD OR ANGLED MOUNTING INSTRUCTIONS
4. Depending on the length of downrod you use, you may
need to cut the lead wires back to simplify the wiring. If
you decide to cut back the lead wires, it is suggested
that you do so in the following manner: Take the lead
wires and make sure that you have pulled them all the
way through the top of the downrod and measure 8 in.
of lead wire, and then cut the excess wire o with wire
cutters (not included).
5. If you decided to cut back the lead wire in Step 4, strip
1/2 in. of insulation from the end of the white wire. Twist
the stripped ends of each strand of wire within the
insulation with pliers (not included). Repeat this step for
black and blue wires.
Important: If you did not cut back the lead wires in
Step 4, Step 5 is not necessary and you may proceed
to Step 6.
6. Install the ball end of the downrod (A) into the opening
of mounting bracket (D). Align one of the four slots in
the downrod with the tab in the mounting bracket (D).
Note: The downrod (A) should not rotate if installed
correctly.
DANGER: Failure to align the slot in the downrod
(A) with the tab of the mounting bracket (D) could
cause the fan to fall, resulting in serious injury or death.
Proceed to the Wiring on page 12.
4
8 in.
6
5
D
A
Tab
Slot
Loading ...
Loading ...
Loading ...