Loading ...
Loading ...
Loading ...
Air Conditioner Features
(continued)
Vent Control - Compact Models
setting is selected, the thermostat maintains the temperature by automatically
turning the heater on and off in response to room temperature Once the room is
warm, adjust the thermostat to a cooler' setting The fan runs continuously to
circulate air in the room
A slight heat odor may come from the unit when first switching to HEATafter the
cooling season isover This odor, caused by fine dust particles on the heater, will
disappear quickly
Vent Control
TheVent Control allows the air conditioner to either recirculateinsideair (CLOSED)
or exhaust air to the outside (OPEN)
o TheCLOSEDposition isusedwhen maximum cooling isdesired,It mayalsobe used
for air recirculation without cooling when the air conditioner is set in the FAN
position
• TheOPENpositionremovesstaleairfrom the room and exhaustsit to the outside
Freshair isdrawn into the room through normal air passagesfound in homes
o The OPENor CLOSEDposition can be usedwith any fan selection
o Forcompact models, push the slide in to CLOSE,pull out to OPEN
Air Directional Louvers
The air directional louvers control the air flow direction. Adjust louvers up, down,
left or right The outside tabs adjust the air up or down Thecenter leversdirect the
air left or right
Care and Cmeaning
Remove
Knobs
Locking
Tabs
e
Pressfirmly on eachsideof
case to release locking tabs 8
Figure1
Removing Decorative Front - Some Compact Modets
Clips
Figure 2
Filter Removal- Some Compact Mode_s
Clean your air conditioner occasionally to keep it looking new. Besure to unplug
the unit before cleaning to prevent shock or fire hazards,
Filter Removal, Some Compact Models.
Somecompactmodels requirethe removalof the front panel to accessthe filter for
cleaning. To remove the front panel, follow the directions below:
Note: Some compact models are equipped with a slide-out rigid filter that is
described under the "Air Filter Cleaning" section It isnotnecessary to remove the
decorative front in these units
Decorative Front Removal and Filter Cleaning
1 Unplug the power cord from the wall outlet
2 Removeknobs by pulling firmly Removefront retaining screw at the bottom of
the front (Figure t)
3 Pressfirmly on each sideof the metal case close to the front and approximately
half way down from the top of the front
4 While pressing on the sides of the metal case,gently pull the front out and lift
up to release it from the case
5 Removefilter by pulling filter straight off of clips (Figure 2) Clean according to
instructions under "Air Filter Cleaning" section
To reinstall:
Properreinstallation of decorative front isimportant for both safetyand performance
I Position filter over clips.
2 Position the top of the decorative front on the top flange of the case and align
the tabs on the front with the slots in the case
3 Carefully pull down on the front to engage the top tabs while pushing the front
over the caseto ensure proper alignment. Theside locking tabs will "click" when
the front is properly installed
4 Install the front retaining screw at the bottom of the unit
5 Install the knobs byaligning them with their shafts and pushing firmly into place
Loading ...
Loading ...
Loading ...