Loading ...
Loading ...
Loading ...
6
NOTE:
It is most important that this appliance is installed and is operating correctly before use.
Installation shall comply with local gas, electrical and health and safety requirements.
This appliance shall be installed with sufficient ventilation to prevent the occurrence of
unacceptable concentrations of health harmful substances in the room, the appliance is
installed in.
Blue Seal Gas Griddles / Electric Oven Ranges are designed to provide years of satisfactory service and
correct installation is essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering gas, electrical, fire safety and health and safety.
Australia / New Zealand: - AS5601.1 - Gas Installations.
Australia / New Zealand: - AS/NZS3000 - Wiring Rules.
Installations must be carried out by qualified persons only. Failure to install equipment to the
relevant codes and manufacturer’s specifications shown in this section will void the
warranty.
Components having adjustments protected (e.g. paint sealed) by the manufacturer are only
to be adjusted by an authorised service agent. They are not to be adjusted by the installation
person.
Remove all packaging and transit protection from the appliance including all protective plastic
coating from the exterior stainless steel panels.
Check equipment and parts for damage. Report any damage immediately to the carrier and
distributor.
Ensure that the 4 adjustable feet are fitted with the protruding centre screw.
Report any deficiencies to the distributor who supplied the appliance.
Check that the available gas supply is correct to that shown on the rating plate located on the front
right hand corner of the bottom sill.
1. This appliance must be installed in a suitably ventilated room to prevent dangerous build up of
combustion products.
2. Installation must allow for a sufficient flow of fresh air for the combustion air supply. Combustion air
requirements are as follows:-
3. Never directly connect a ventilation system to the appliance flue outlet.
4. Position the appliance in its approximate working position.
5. All air for burner combustion is supplied from beneath the unit. The legs must always be fitted and
no obstructions placed under or around the base of the appliance, as obstructions will cause incor-
rect operation and / or failure of the appliance.
NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system to
the appliance flue outlet.
Combustion Air Requirements:
GPE506 / GPE56 GPE508 / GPE58
Natural Gas 19 m
3
/hr 26 m
3
/hr
LP Gas / Butane 20 m
3
/hr 27 m
3
/hr
Town Gas 19 m
3
/hr 26 m
3
/hr
Loading ...
Loading ...
Loading ...