Tripp Lite B140-004 Owner's Manual

Loading ...

Extender/Splitter Daisy-Chain Installation

Connect the B140-1P0 DVI-D Single Link Connector to the monitor or

connect the B140-1A0 or B140-1A0-WP-1 to the monitor using a

Tripp Lite P561-Series DVI-D Single Link Cable. The green RJ45 LED on

the B140-1P0 illuminates to indicate the unit is receiving power from

the monitor.

Repeat step 12 for each additional monitor you are connecting.

Turn on the power to the DVI source. The orange RJ45 LEDs illuminate

on the B140-004 and B140-1A0 and the orange LED illuminates on

the B140-1A0-WP-1 to indicate the unit is receiving a signal from the

source. The screen should now be displayed on the connected monitors.

If necessary, use the Equalization control on the B140-1A0 or

B140-1A0-WP-1 to adjust the video image.

Note: An improper Equalization setting can cause the monitor not to display a

picture at all. Try each Equalization setting until an acceptable image is displayed.

Extender/Splitter Daisy-Chain with Remote/

Repeater Installation (B140-004 extender/splitter,

and B140-1A0 and B140-1A0-WP remote receivers only)

Notes:

1. Test to make sure the entire installation works properly before pulling cables

through ceilings/walls.

2. To achieve maximum distance and performance, use 24 AWG solid wire

Cat5e/6 cable. Using stranded wire Cat5e/6 cable, or cable with a gauge (AWG)

size higher than 24 AWG will result in shorter extension distance. All Tripp Lite

N202-Series Cat6 cables are made with 24 AWG solid wire cabling.

17-08-508-933776.indb 22 11/27/2017 11:47:50 AM

Loading ...

Tripp Lite B140-004 4-Port DVI over Cat5/6 Splitter/Extender, Box-Style Transmitter