Tripp Lite B140-004 Owner's Manual

Loading ...

Extender/Splitter with Remote/Repeater Installation

(B140-1A0 and B140-1A0-WP-1 remote receiver units only)

To add a third remote/repeater unit, repeat steps 8 through 10. To ﬁnish

your installation with a B140-1A0 or B140-1A0-WP-1 remote receiver

unit, proceed to step 12.

Using Cat5e/6 cable, connect the RJ45 OUTPUT port on the last remote/

repeater unit to the RJ45 INPUT port on a B140-1A0 or B140-1A0-

WP-1 remote receiver unit.

Connect a monitor to the DVI OUTPUT port on the remote receiver unit

using a Tripp Lite P561-Series DVI-D Single Link Cable.

Connect the external power supply to the remote receiver unit and plug

it into a Tripp Lite Surge Protector, PDU or UPS. The green RJ45 LEDs on

the B140-1A0 and the green LED on the B140-1A0-WP-1 illuminate to

indicate that the unit is receiving power.

Repeat steps 5 through 14 for each additional RJ45 output port on the

local transmitter unit.

Turn on the power to the DVI source. The orange RJ45 LEDs on the local

transmitter, remote/repeater and B140-1A0 illuminate to indicate a

signal is being received from the source. The orange LED on the

B140-1A0-WP-1 illuminates to indicate a signal is being received from

the source.

If necessary, use the Equalization control on the remote/repeater unit(s)

and remote receiver unit to adjust the video image.

Note: An improper Equalization setting can cause the monitor not to display a

picture at all. Try each Equalization setting until an acceptable picture is displayed.

17-08-508-933776.indb 19 11/27/2017 11:47:49 AM

Loading ...

Tripp Lite B140-004 4-Port DVI over Cat5/6 Splitter/Extender, Box-Style Transmitter