Yamaha TIO1608-D Dante-Equipped I/O Rack

User Manual - Page 16

For TIO1608-D.

PDF File Manual, 24 pages, Read Online | Download pdf file

TIO1608-D photo
Loading ...
Loading ...
Loading ...
How to read the indicators
-
16
-
Owner’s Manual
Tio1608-D
How to read the indicators
You can use the [SYSTEM] and [SYNC] indicators to confirm the unit's status.
The indicators can relay operational status, error status, and warnings.
Error status
If one of the following errors has occurred, the device will not operate. Until the error is resolved, the green SYSTEM indicator
will be turned off, and all indicators for all I/O channels will continue to flash.
In addition, certain errors will cause the red SYSTEM indicator to light or flash.
The following errors affect the settings or the hardware. However, the device will still be usable. The green SYSTEM indicator
will light, and all indicators for all I/O channels will work normally.
In addition, certain errors will cause the red SYSTEM indicator to light or flash.
[SYSTEM] Indicators Description Possible Solution
Off Flashes 2 times
Internal Dante error has occurred. The unit is malfunctioning. Please contact
your nearest Yamaha representative.
Off Flashes 3 times
MAC address setting is damaged and Dante
communication is not possible.
Off Lit
Duplicate UNIT ID was found. Make sure each UNIT ID is only used once
on the Dante network.
[SYSTEM] Indicators Description Possible Solution
Lit Flashing
The number of Dante transmit flows
exceeded the limit.
Reduce the number of flows by, for example,
using Dante Controller to change some of the
transmit flows to multicast.
Lit Flashes 2 times
Error occurred when communicating with the
head amp.
Turn the unit off and then on again. If this does
not resolve the problem, please contact your
nearest Yamaha representative.
Lit Flashes 3 times
Internal memory has been corrupted. If using [RESUME] mode, turn the unit off
and then on again. If this does not resolve
the problem, please contact your nearest
Yamaha epresentative.
Lit Lit
You changed the positions of the device
setting DIP switches, or changed the Dante
settings from Dante Controller. Therefore, the
positions of the device setting DIP switches
do not match the actual Dante settings.
If the Device Lock setting was enabled from
Dante Controller, disable the setting, or
check the device setting DIP switch
positions, and set them to accommodate the
current situation.
Loading ...
Loading ...
Loading ...