Loading ...
Loading ...
Loading ...
14
Stop the engine (B19)
- Allow the engine to slow down to idling speed
without any throttle.
- Move the control switch (18) downwards to
“STOP”.
Start when the engine is warm
- The procedure is identical for starting when the
engine is cold. However, in this case the choke
lever (17) remains fully pushed in.
Working with the chainsaw
Wear gloves, ear protectors, protective clothing
and a helmet with a visor.
Never saw above shoulder height.
Never saw with one hand.
Never saw on a ladder, in a tree or if you are not
standing on firm footing.
Check the following before starting the engine:
- Is the saw chain tension correct ?
- Is the oil tank full?
- is the chain brake released?
- Start the chainsaw.
Holding the saw (B20)
Hold the front handle (9) in your left hand and the
rear handle (10) in your right hand.
Switch off the saw
Release the throttle lever (19).
Set the control switch (18) to <<STOP>>). Do not
put down the chainsaw until the chain has stopped
moving.
Carburettor adjustment
The carburettor has been set at the factory to
guard towards your body. The chain will start
when the saw is switched on.
Machine instructions
Check the chainsaw at regular intervals for signs
of damage.
Ensure that all the parts work correctly and properly.
Please note that all parts must be fitted correctly
in order to function properly.
Have damaged parts repaired immediately in an
after-sales workshop.
Start when the engine is cold (B17-B19)
- Place the petrol chainsaw safely on the ground.
- Move the control switch (18) upwards.
- Gently press primer button (23) often enough that no
more bubbles are visible (approx. 5-6 times).
- Pull the choke lever (17) out as far as possible.
- Adopt a safe posture.
- Hold the petrol chainsaw securely on the ground
using your left hand.
- Place your right foot in the shaft of the rear
handle (10).
- Pull the starter cable (11) out as far as possible 3
to 5 times.
- Choke level jumps back automatically when pressing
the trigger.
- Pull the starter cable (11) several times quickly
and forcefully right to the end of the cable until
the engine starts.
Warm up the engine for 30 seconds. Tighten and release
the trigger.
G
B
Loading ...
Loading ...
Loading ...