Loading ...
Loading ...
Loading ...
Enigma-XO Maintenance checklist
◻ Guide rail level and tight
◻ Guide rail brackets tight to the walls
o All set screws tight
◻ Panel glass secure
◻ Panel glass brackets tight
◻ Guide block square to the threshold and glass
◻ Proper clearance beneath the door glass between the threshold and within the guide block
◻ Door Glass adjusted so that the Bulb vinyl seal makes even contact with the wall
◻ Wheel assemblies tight
o Wheel roller bolts tight
o Wheel assembly safety set screws tight and accessible
◻ Stoppers tight and positioned correctly
o Panel-side stopper installed into the pre-drilled hole in the guide rail
o Adequate Handle clearance when the door is fully open
o Door-side stopper positioned at approximately 3” (+/- 1/8”) (as measured from the
wall to the center of the stopper)
◻ Stopper stops the door and bulb vinyl seals to the wall
◻ SafeStop bumper secure to the wall
◻ Bottom Rollers should make contact with the guide rail.
◻ Remove vinyl seals to inspect the edges of the door glass for concealed damage
o Damaged glass must be replaced!
◻ Replace damaged or missing vinyl seals
Product Maintenance
BASES and BACKWALLS: To ensure long lasting life for your acrylic back walls: wipe them off after each
use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream based cleaners.
Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal brushes or scrapers that
could scratch or dull the surface.
GLASS: To ensure long lasting life for your glass shower products: wipe them off after each use with a
soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent soap buildup
and water spots (Hard water can etch the surface of the glass over time if left to dry). To prevent
scratching the surface: never use abrasive cleaners or cleaning products that contain scouring agents.
Never use bristle brushes or abrasive sponges that may scratch the surface.
HARDWARE: To ensure a long lasting finish: wipe off the metal parts after each use with a soft cloth.
Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If accidentally
used, rinse the surface as soon as possible to prevent damage to the finish (peeling or corrosion).
After cleaning the polished finishes, rinse thoroughly and wipe dry with a soft cloth.
Clean stainless steel surfaces at least once a week. When applying stainless steel cleaner or polish to
stainless steel hardware, work with (not across) the grain. Never use an abrasive sponge or cloth, steel
wool or wired brush as these may permanently scratch the surfaces.
NOTE: To maximize the life of your door, it is important to regularly inspect the
glass and other hardware for misalignment, proper attachment, and/or damage.
Contact DreamLine
®
with any questions or concerns.
©2018 DreamLine. All Rights Reserved
29ENIGMA-XO manual Ver 1 Rev 2 03/2018
Loading ...