Loading ...
Loading ...
Loading ...
Installation steps
©2018 DreamLine. All Rights Reserved
9ENIGMA-XO manual Ver 1 Rev 2 03/2018
!
Threshold must be level.
Note: The minimum threshold requirement for
the ENIGMA-XO is 2-3/4” of flat threshold
space.
Fig 2
Use a metal file to
deburr the cut end
Fig 1
W
Top
Middle
Bottom
2-3/4”
minimum
door end
door end
glass bracket
holes
2. The Upper Guide Rail (#03) has been pre-cut
for the model width of: 48”, 60” or 72”.
(Note: The actual rail is shorter than the model
width by design).
Cut the Upper Guide Rail (#03) from the door end only,
which is the end that is farther from the Glass
Bracket (#07) holes. (Fig 2)
The length to cut off will be (L) :
Model Width – finished opening W = cut off length (L)
*FOR EXAMPLE:
If the model width is 48” and the finished opening is 46”,
then you will need to cut 2” off from the door end of the
Guide Rail: Example: 48” – 46” = 2” cut off
*Note that this is only an example and the actual
cut-off length will vary based on the actual finished
opening dimension.
1. Measure the distance between the two finished
walls at the top, middle and bottom. Measure the
width at the model height (62” or 76”).
This top measurement will be the “W” dimension
used to cut the guide rail to the correct size for the
finished opening.
Also, check the threshold for level and the walls for
plumb. (Fig 1)
Loading ...
Loading ...
Loading ...