Loading ...
Loading ...
Loading ...
©2018 DreamLine. All Rights Reserved
17ENIGMA-XO manual Ver 1 Rev 2 03/2018
Fig 14b
use a pencil or a
center-punch to
mark the hole
1
2
*see note
** use anchor
with tile threshold
3
4
5
protective
padding
protective
padding
!
M5 X 10
Part#22 - Small Stationary Glass Bottom Bracket
ST4.2 X 40
NOTE: Before you install the Stationary Glass (#02), take
the Door Glass (#05) into the shower area and lean it
against the wall with the handle holes on the correct side.
After the Stationary Glass (#02) is installed, it may not be
possible to easily get the door glass into the shower.
Always use padding to protect the glass and shower
surfaces.
NOTE: DO NOT attach the handle to the door glass until
instructed to do so.
DO NOT attempt to lift the door glass with the handle as
this may result in damage to the glass and/or serious
personal injury. Use a professional grade glass suction cup
and an assistant.
13b. If installing the 72” model, repeat Step #13a for the
Small Stationary Glass Bottom Bracket (#22). Loosen the
set screw and remove the Guide Block Face Plate.
*NOTE:
◾For installation into an Acrylic Threshold:
drill an Ø1/8”(3mm) hole and use the ST4.2 x 40mm
Countersunk Screw (#17)
OR
◾For installation into a Tile Threshold:
drill a Ø5/16”(8mm) hole and use the ST4.2 x 40mm
Countersunk Screw (#17) (with Anchor (#09b) for tile)
Apply silicone to the underside of the Guide Block (#12) and
screw the Guide Block (#12) to the threshold. (Fig 14b)
The Small Stationary Glass Bottom Bracket (#22) must be
screwed down.
Loading ...
Loading ...
Loading ...