Loading ...
Loading ...
Loading ...
PORTABLE MUSIC BOOMBOX GX-BT9
REMOTE
SENSOR
■ Tuning
1 Press the ON/STANDBY button to turn the power on.
2 Press the TUNER button on the remote control or TUNER/
AUDIO IN button on the main unit repeatedly to select FM Stereo
or FM Mono.
3 Press the TUNING ( or ) button on the remote control to tune
in to the desired station.
Manual tuning:
Press the TUNING ( or ) button repeatedly to tune in to
the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for more than
0.5 seconds, scanning will start automatically and the tuner
will stop at the rst receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING (
or ) button
again.
To receive an FM stereo transmission:
Press the TUNER button to select stereo mode and “ST” indicator
will be displayed. “
” will appear when an FM broadcast is in
stereo.
If the FM reception is weak, press the TUNER button to extinguish
the “ST” indicator. The reception changes to monaural, and the
sound becomes clearer.
■ Memorizing a station
You can store 40 FM stations in memory and recall them at the
push of a button. (Preset tuning)
1 Perform steps 1 - 3 in “Tuning”.
2 Press the MEMORY button.
3 Within 30 seconds, press the PRESET (
or ) button to select
the preset channel number. Store the stations in memory, in
order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY button to store that
station in memory. If the “MEM” indicator and preset number
disappear before the station is memorized, repeat the operation
from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a preset
station. When a new station is stored in the memory, the station
previously memorized for that preset channel number will be
erased.
Note:
The backup function protects the memorized stations for a few
days should there be a power failure or the AC power cord become
disconnected.
■ To recall a memorized station
1 Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
■ To scan the preset stations
The stations saved in the memory can be scanned automatically.
(Preset memory scan)
1 Press the PRESET (
or ) button for more than 0.5 seconds.
The preset number will ash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
■ To erase entire preset memory
1 Press the ON/STANDBY button to enter the power on.
2 Press TUNER button on the remote control or TUNER/AUDIO IN
button on the main unit to select TUNER function.
3 Press and hold CLEAR button on the remote control until
“TUNCLEAR” appears.
Listening to the radio
E-18
Loading ...
Loading ...
Loading ...