Loading ...
Loading ...
Loading ...
Section 3: Assembly
Beforeconnectinggarden hose to water inHet_inspect
inHetscreen(Figure6).CHean screenifitcontainsdebris_
rephce it if it is damaged. DO NOT RUN PRESSURE
VVASHER IF SCREEN IS DAHAGED.
Inspect inHet
screen. DO NOT
use if damaged;
dean if dirty,
4. Run water through garden hose for 30 seconds to
dean out any debris.Turn off water.
[MPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 6).
Damage to equipment resulting from failure to follow this
instruction will void warrant),,
6. Turn ON water and squeeze trigger on spray gun to
purge the pump system of air and impurities.
WANNING
A[w,ays wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection.
Checklist Before Starting[he
Review the unit's assembly to confirm you have performed
at[ of the following:
[. Hake sure handle is in place and secure.
Z Check that oil has been added to the proper [eve[ in
the engine crankcase.
3. Add proper fuel to fuel tan[<.
4. Check for proper[>, tightened hose connections.
5. Check to make sure that there are no kinks_ cuts_ or
damage to the high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo UseYour
PressureVVasher" before using the pressure washer.
Loading ...
Loading ...
Loading ...