Loading ...
Loading ...
Loading ...
2. Place saw on cabinet so that holes in bottom of
saw line up with holes in top of cabinet.
3. Install bolts, Iockwashers, and nuts as shown.
Tighten securely using a 7/16-inch wrench or
socket. The front two bolts hold the saw, lower
wheel cover, and the cabinet together. Install
these bolts from the bottom side.
4. After the band saw has been mounted to the
cabinet, go back and tighten all the nuts that
were previously hand tightened using a 7/16-
inch wrench or socket.
I
MOUNTING DOOR
Tools needed: 7/16" wrench or socket and phillips
screwdriver.
1. Locate the two (2) door hinges and four (4) 10-10
x 1/2 plastite screws. Mount hinges on either side
of the door with phillips screwdriver.
2. Locate the four (4) truss head bolts, Iockwasher
and hex nuts to attach door hinges to the side
panel. Tighten hex nuts with a 7/16" wrench or
socket.
3. Locate the magnetic catch, the magnetic catch
stop plate, two (2) 6-10 x 1/2 pan head screws
and two (2) 6-32 x 3/8 pan head screws. Attach
the magnetic catch to the door with the two (2)
6-10 x 1/2 pan head screws using a phillips
screwdriver. Attach the magnetic catch stop
plate to the side panel opposite the side the
hinges are to be mounted. Use the two (2) 6-32 x
3/8 pan head screws to mount top plate. Adjust
the stop plate if necessary with phillips screw-
driver for desired closure.
PANEL
MAGNETIC CATCH
STOP PLATE
MAGNETIC
CATCH
J
DOOR HINGE
DOOR
16
Loading ...
Loading ...
Loading ...