Loading ...
Loading ...
Loading ...
I NSTALLATI 0 N
Connecting the Water Supply
(select models)
To reduce the risk of injury or death, follow
basic precautions, including the following:
Read all instructions before installing ice maker.
Do not attempt installation if instructions are not
understood or if they are beyond personal skill
level.
Observe all local codes and ordinances.
Do not service ice maker unless specifically
recommended in Use & Care Guide or published
user-repair instructions.
Disconnect power to refrigerator before installing
ice maker.
• Water damage due to an improper water
connection may cause mold/mildew growth. Clean
up spills or leakage immediately!
Materials Needed:
• '2' outer diameter flexible copper tLIbmg
• Shut-off valve (requires a 'Z' hole to be drilled into
water supply hne before valve attachment)
• Adjustable wrench (2)
• '_" hex nut driver
Notes:
• Use copper tubing only for installation. Plastic is
less durable and can cause damage.
• Add 8' to tubing length needed to reach water
supply for creation of service loop.
Create service loop with
copper tubing (nllnlnlunl 2'
diameter). Avoid kinks m the
copper tubing when
bending the service loop. Do
not use plastic tubing.
2' diameter
I111n 1I11LII11
2. Remove plastic cap from water valve
inlet port.
To avoid property damage or possible injury,
follow basic precautions, including the
following:
• Consult a plumber to connect ;;," O.D. copper
tubing to household plumbing to assure
compliance with local codes and ordinances.
• Confirm water pressure to water valve is between
35 and 100 pounds per square inch, 20 pounds
per square inch without filter.
Do not use a self-piercing or %6"saddle valve.
Both reduce water flow and can become clogged
over time, and may cause leaks if repair is
attempted.
• Tighten nuts by hand to prevent cross threading.
FmBh tightening nuts with phers and wrenches.
Do not over-tighten.
• Wait two to three hours before placing refrigerator
into final position to check and correct any water
leaks. Recheck for leaks after 24 hours.
• Verify the copper tubing under the sleeve is
smooth and free from defects. Do not reuse an
old sleeve.
.
.
Place brass nut (A) and sleeve (B)
o,1 copper tube end as illustrated.
Reminder: Do not use an old
sleeve. The nLIt and sleeve are
provided m the Use and Care
packet.
Place end of copper tLIbing into
water valve inlet port. Shape
tubing shghtly. Do not kink - so
that tubing feeds straight into inlet
port.
Iii
Ii i,,
i i
iI , ,
,,"
,' L
,'t_=B
' _]_,A
II
,,,
Loading ...
Loading ...
Loading ...