Loading ...
Loading ...
Loading ...
9
The following function buttons (AUTO, SPOT & CHARGE) are located on the control panel
on top of the R-Vac and will only operate when the R-Vac is not located on the charging
station. For general daily use, we recommend using the remote control to start the R-Vac
from the charging station.
AUTO button (Automatic Cleaning)
IMPORTANT: Before using your vacuum, clear any clutter or loose cords in the area you intend
to clean.
The AUTO button is the main method most people use to start their R-Vac.
Press the AUTO button to let R-Vac start cleaning.
Once R-Vac starts, it uses an algorithm to work through the room with a series of patterns (a
series of zig-zags, increasing spirals and edge following) to maximise coverage. During this time,
the R-Vac can cover areas more than once - don’t be concerned by this, it is part of the normal
cleaning process.
Press any button on the control panel to stop the vacuum cleaning.
SPOT button (spot cleaning)
The SPOT button is ideal to clean up small spills.
Pressing the SPOT button will automatically clean an area of approximately 1 square meter. The
vacuum will operate in spiral mode for 3 minutes and then switch itself off.
NOTE: To stop the vacuum when in spot cleaning mode, press any button on the control panel.
CHARGE button
IMPORTANT: Ensure you have the Charging Station set up.
Press the CHARGE button and the vacuum will automatically stop the vacuum motor (to preserve
power) and search for the charging station. This is achieved by methodically working through the
cleaning area and periodically stopping to search for the docking station.
If the charging station is detected, the vacuum will then make its way to the charging station,
dock automatically and begin to charge.
Once on charge the Power indicator will illuminate and ash.
Loading ...
Loading ...
Loading ...