Loading ...
Loading ...
Loading ...
Page 13 of 66
BUILT-IN INSTALLATIONS
The Crown Verity Built-In Grills and Side Burners are designed for easy installation into masonry
enclosures.
NOTE: Crown Verity built-in grill/side burners are intended either for installation in a built-in
enclosure constructed of non-combustible materials or for an installation in a built-in enclosure
constructed of combustible material when installed with an insulated jacket.
The built-in enclosures should have ventilation holes to prevent gas build-up in the event of a
leak. The deck ledges and counter should be flat and level. (refer to ANSI Z21.58 Standard for
Outdoor Cooking Gas Appliances, Section 1.7 Enclosures For Self Contained LP-Gas Supply
Systems).
For non-combustible applications, the grills and side burners drop into the opening specified in
the cutout detail drawings (See “Figure 3”) and hangs from its countertop trim.
Pay special attention to the provisions shown for gas line hook-up (See “Appendix “B” for
further details).
The Built-In and Modular grills and side burners, when equipped with one of the optional light
packages, requires that the appliance be connected to a 120-volt, 60 hertz, 15-amp GFI certified
outlet by a qualified electrician.
CLEARANCE TO COMBUSTIBLES
Minimum clearance from the sides and back of the grill/side burner to adjacent construction
below and above the countertop surface is 12” from the sides and 18” from the back of the
hood.
A minimum of 12 inches (30.5 cm) clearance is required on the left and right side of the grill
above the countertop for the rotisserie motor and spit rod.
If the grill/side burner is to be placed into a combustible enclosure, an approved insulated
jacket is necessary and is available only through your Crown Verity dealer. Crown Verity
insulated jackets have been designed and tested specifically for your grill.
REAR HOOD CLEARANCE
A 3.5 inch (8.9 cm) clearance is required behind the rear flange of the grill to allow the hood to
open unobstructed. The grill exhausts combustion products and cooking greases to the back.
Do not locate the grill where this exhaust will be difficult to clean.
Loading ...
Loading ...
Loading ...