Loading ...
Loading ...
Loading ...
ADJUSTING MITER GAUGE __ (_, ._..WARNING: FOR YOUR OWN SAFETY, TURN "_._, _._ PG
SWITCH "OFF" AND REMOVE PLUG FROM SQUARE__
POWER SOURCE OUTLET BEFORE MAKING ANY
ADJUSTMENTS,
MITER GAUGE
NOTE: The graduations on the miter gauge provide
accuracy for average woodworking. In some cases
where extreme accuracy is required when making
angle cuts, for example, make a trial cut and then
recheck it with an accurate square or protractor.
If necessary, the miter gauge head can be swiveled
slightly to compensate for any inaccuracy.
The HEAD should be SQUARE (90° ) with the bar
when the pointer points to "O".
To check for squareness, place an accurate square
on the miter gauge. If the head is NOT SQUARE with
the bar:
1. Loosen the ock knob
.=---LOCK KNOB
_INTER
2. Position the head square with the bar . tighten
the lock knob.
3. Loosen the screw and adjust the pointer, so it
points to zero.
The swiveling movement of the head can be
adjusted by tightening or loosening the set screw
located in side of the head using the 1/8 in. setscrew
wrench.
GETTmNG TO KNOW YOUR SAW
ANTIKICKBACK
MITER GAUGE 6 BLADE GUARD 8 PAWLS
LOCK KNOB SAW RLAD 4
\ SPREADER RIP FENCE
5 MITER GAUGE /
/
INSERT
HOLES FOR
ATTACHING
FACING
9 E_
3 TILT HANDWHEEL
\
2 RIP FENCE
HANDWHEEL LOCK KNOB
/
/
/
]
ON-OFF
SWITCH
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the
blade guard is correctly installed and operating
properly.
The On-Off Switch has a locking feature. THIS
FEATURE IS INTENDED TO PREVENT
UNAUTHORIZED AND POSSIBLE HAZARDOUS
USE BY CHILDREN AND OTHERS.
A. TO turn saw ON... stand to either side ofthe
blade never in line with it... insert finger
under switch lever and pull END of lever out.
@
KEY
(YELLOW PLASTIC)
2O
Loading ...
Loading ...
Loading ...